Pete, No, or at least not to my knowledge, and No! Regards, David
----- Original Message -----
From: "Pete Lawless" <pete@lawless.info>
Sent: Tuesday, July 15, 2008 10:19 AM
Subject: RE: Europa-List: 914 EGTs - Normal and Max.
>
> Hi David
>
> As a matter of interest do Rotax publish a limit for turbo inlet
> temperature
> and do you monitor it?
>
> Pete
>
> -----Original Message-----
> From: owner-europa-list-server@matronics.com
> [mailto:owner-europa-list-server@matronics.com] On Behalf Of David Joyce
> Sent: 15 July 2008 09:56
> To: europa-list@matronics.com
> Subject: Re: Europa-List: 914 EGTs - Normal and Max.
>
> <davidjoyce@doctors.org.uk>
>
> Darin, The warning and alarm limits for 914 EGTs given by Rotax in the
> Flydat manual are 880 & 900 degrees Centigrade respectively. Mine usually
> run around the 700 mark with the rear pair being perhaps 60 deg hotter.
> 880C. is 1616F, and 760 is 1400F so you haven't exceeded limits but seem
> to
>
> be running hotter than I do. But on the other hand if you are just doing
> ground runs you aren't getting much in the way of cooling, & new engines
> also run relatively hot until they have polished all the rough surfaces
> off
> a bit. Regards, David Joyce, G-XSDJ
> ----- Original Message -----
> From: "darinh" <gerns25@netscape.net>
> To: <europa-list@matronics.com>
> Sent: Monday, July 14, 2008 11:01 PM
> Subject: Europa-List: 914 EGTs - Normal and Max.
>
>
>>
>> You guys flying 914's, what are you seeing on your normal operating range
>> for EGTs? What is the max set at by Rotax? I would think this
>> information would be in the manuals but I have yet to find it. Any
>> personal experience would be great. I ran my 914 yesterday and had temps
>> as high as 1530 around 4300 rpm.
>>
>> I posted this on the Rotax engines forum but no replies...I figured this
>> forum would have better results.
>>
>> --------
>> Darin Hawkes
>> Series 7 (Airworthiness in Hand - building courage for Maiden flight)
>> 914 Turbo
>> Kaysville, Utah
>>
>>
>>
>>
>> Read this topic online here:
>>
>> http://forums.matronics.com/viewtopic.php?p=192725#192725
>>
>>
>>
>>
>>
>>
>>
>>
>>
>>
>>
>>
>>
>
>
> --
> This message has been scanned for viruses and
> dangerous content by Houxou, and is
> believed to be clean.
>
>
>
|