0simple means by which this can be accomplished.=C2-=0A=C2-=0A=0AThere is an
adjustment
available in the position of the FL21 "Horn" which can be used to allow
a bit more flap movement. See page 28M-11. There is also some adjustment
available in the "Fork Assembly" (175-601-208) which is installed at both ends
of the "Flap Push Rod (FL20). See page 28M-17. These adjustments could be
used to proved some limited additional flap extension, but probably at the cost
of a less than fully retracted flap and some loss of cruise speed due to the
added drag. I'm not sure how much approach speed reduction could be gained,
but I expect it would be minimal.=C2-=0A=C2-=0A=0AI guess you could also machine
a new, longer, FL19 "
H
f
t
2
|