Will,
Get your ruler out......
The spar cap [ glass rovings] should be about 42mm deep at the point direct
ly above the Q/C hole,[ from the top of the spar to the wood] the hole itse
lf should be about 61mm from the top.
The quality control of the placement of rovings was a bit suspect at one ti
me, I had to inspect for minimum cap material before they went out. Many we
re too thick, you may strike lucky if the one you have is too deep [ as in
you have 42mm above the top of the hole you have drilled ?] and what you ha
ve is rovings where wood should be ?
There will always be a fix, so don't fret too much.
Cheers,
Nev.
-----Original Message-----
From: William Daniell <wdaniell@etb.net.co>
Sent: Mon, 14 Mar 2011 2:38
Subject: Europa-List: quick connect disaster area
Fred
ood point well made!
erewith pic of disaster area :-(
Ill
-----Original Message-----
rom: william.daniell@longportsecurity.com
mailto:william.daniell@longportsecurity.com]
ent: 13 March, 2011 20:15
o: William Daniell
ubject: IMG00300-20110313-2013.jpg
illiam Daniell
|