Moisture may have some effect but probably not the whole story. I
found the nylon rods that came with the kit were slightly over sized.
You have to hammer it into the socket which made removal nearly
impossible. I bought new rods from Mcmaster which was easier to slide
into the sockets and even after several years it is still snug and
tight but not impossible to remove.
On Wed, Aug 31, 2011 at 8:01 AM, h&jeuropa <butcher43@att.net> wrote:
>
> We found that putting the outrigger assembly (or for install, just the nylon
rod) in a freezer for a short time made it shrink just enough to make the job
easy.
>
> Jim & Heather
> N241BW
>
>
> Read this topic online here:
>
> http://forums.matronics.com/viewtopic.php?p=351080#351080
>
>
|