You could drill and thread the heads of the parallel pins and use a bolt to
Jack the out if needed.
Regards
Bob Harrison G-PTAG
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com] On Behalf Of GRAHAM
SINGLETON
Sent: 14 October 2012 18:14
Subject: Re: Europa-List: Re: Mod 73
No, they would distort the torque tube which must be perfectly circular
Graham
_____
From: Pete <peterz@zutrasoft.com>
Sent: Sunday, 14 October 2012, 14:04
Subject: Re: Europa-List: Re: Mod 73
I fully understand the requirement for an interference pin fit to avoid the
hammering out of the holes over time.
That said, could "taper pins" be used?
cheers,
Pete
|