I did the same as Richard W , I drew a circle on a piece of the 12mm
plywood the same dia as the bracket tried it in place with the wings in
position then once I had the thickness correct blended out from the
bracket circle to the edge this made the outside dia about 3 1/2 inches
. Then glue and glass as per manual. Good luck Richard C
From: Richard Wheelwright
Sent: Saturday, June 1, 2013 9:55 AM
Subject: Re: Europa-List: Rear Trailing Edge Lift Pin Socket Mounting
Tony,
Depending on the thickness you need. I used waste from the tri-gear
leg sockets ribs. I cut a 2 1/2 inch circle with a hole saw, then it was
cut down through its edge at the angel needed to contour the side of the
fuselage. Worked a treat.
===================
Richard Wheelwright
===================
From: Tony Renshaw <tonyrenshaw268@gmail.com>
Sent: Saturday, 1 June 2013, 9:17
Subject: Europa-List: Rear Trailing Edge Lift Pin Socket Mounting
<tonyrenshaw268@gmail.com>
I would like to request advice regarding methods of shaping the ply
inserts for the rear Trailing Edge Lift Pin Sockets if anyone has
digressed from the manual, either by material/medium or method. Thanks.
Regards
Tony Renshaw
Sydney st"
target="_blank">http://www.matronics.com/Navigator?Europa-Listhttp://fo
rums.matronbsp; nbsp; -Matt com/contribution"
target="_blank">http://www.matronics.com/contribution
|