Hi David
Was the prop full fine? I had understood that the constant speed units
would run the prop full fine in the event of engine stoppage. If it was be
worth trying manually setting full course and see if it makes a difference.
Regards
Pete G-RMAC
-----Original Message-----
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com] On Behalf Of David Joyce
Sent: 12 August 2013 10:05
Subject: Europa-List: stopping engine in flight
Some time ago there was some discussion about stopping &
restarting the engine in flight. Yesterday I was
experimenting with this in order to research glide angles
with engine idling and actually stopped. I was frustrated
in this because with the ignition off my prop continued to
windmill with the speed pulled right back to 50kts. This
is with a Rotax 914 and a Woodcomp SR3000W, and I guess it
is because this prop offers appreciably more blade area
than say Warp drive blades. For what it is worth the
engine fired up again immediately on switching the
ignition back on without needing the starter.
Regards, David Joyce, G-XSDJ
--
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.
|