Ha Alan,
Are you going to Laddingford this weekend?
Pete
_____
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com] On Behalf Of Alan Burrill
Sent: 15 August 2013 12:35
Subject: Re: Europa-List: Coms port settings
Ah now I get it.
NEMA output and then RMC & RMB.
Based on what's used on my Trutak set up.
Speed is 4800
Probable best if you ring or let me know when you next at WAP and I can
help.
Alan
Sent from my iPhone
On 15 Aug 2013, at 12:11, " Peter Jeffers" <pjeffers@talktalk.net> wrote:
Hi Alan,
OK my problem is what boxes to tick on the Lowrance setup.
The first page gives a choice of NMEA output, NMEA input, or NMEA GPS
input. I presume I should tick the first one ie NMEA output.
Once you make this choice then you have to CONFIGURE NMEA, this gives me
the option of choosing one or more of the following:- GLL, RMC & RMB,
GGA, GSA & GSV, or APB.
All this leaves me stone cold as I have no idea what any of these options
mean or refer to. Have you any thoughts on any of that?
Hopefully
Pete
_____
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com] On Behalf Of Alan Burrill
Sent: 14 August 2013 22:26
Subject: Re: Europa-List: Coms port settings
Peter,
The manual here:
<http://www.sportys.com/source/slashpages/manuals/2034.pdf>
http://www.sportys.com/source/slashpages/manuals/2034.pdf
Appears to quite detailed on Page 82. The only ref to manufacturers is with
ref to the wiring for the unit.
Is it the settings or the wiring?
Alan
Sent from my iPad
On 13 Aug 2013, at 13:22, " Peter Jeffers" <pjeffers@talktalk.net> wrote:
Hi Craig,
Thanks for that. I have got the original manual but all it says about the
settings is that you need to set the send and receive ports according to
Lowrance support. Lowrance support does not support the 2000c any more and
have not do so for about three years hence they are useless as far as
assistance is concerned.
I guess I need help from someone who set their system up a few years back.
Pete
_____
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com] On Behalf Of craig
Sent: 13 August 2013 13:08
Subject: RE: Europa-List: Coms port settings
I have had some success getting workshop manuals etc for older stuff off
ebay, people running the manuals
Through a photo copier and outputting it to a PDF file then selling the
thing on CD for a few bucks
Worth a look, good luck
craig
<http://www.matronics.com/Navigator?Europa-List>
http://www.matronics.com/Navigator?Europa-List
<http://forums.matronics.com> http://forums.matronics.com
<http://www.matronics.com/contribution>
http://www.matronics.com/contribution
|