Jeremy
When I started building nev told me to cut out the entire monowheel hole
and cover it up with a piece of aluminum which I did. Made life a lot
easier. I can't imagine trying to do all the plumbing without the access.
Will
On 14 Oct 2014 19:54, "Jeremy Fisher" <jffisher@gmail.com> wrote:
>
> I am looking for some advice on whether I can put an access panel in the
> bottom of the fuselage of my Tri Gear where the wheel is retracted on the
> monowheel. I was planning to put my fuel panel (pumps and non directional
> valves) in there, but access from above is too restricted for me to be able
> to get in to check or repair. It seems to me that the bottom of the
> fuselage in this area should not be a stressed panel. However before I cut
> a large hole in my fuselage, I want to get confirmation that I am not going
> to weaken it! I am thinking of a hole of about 12" by 9". Am I out of
> line? Grateful for any advice.
>
> Jerry Fisher
>
>
|