I use a piece of pipe insulation placed into the rudder gap so the rudder is
pushed
hard to starboard. Crude but cheap and very light.
Kevin Challis
G ODJG
Tri gear 912S
> On 2 Aug 2015, at 11:33, Rick Moss <Rkwmoss@gmail.com> wrote:
>
>
> I'm trying to come up with a lightweight and effective design for a rudder
> gust
lock, ideally that can be 3d printed on an 8" cube 3d printer (because that's
what I have).
>
> I'm thinking something the clips onto the starboard rudder horn and attaches
to the tail tie-down, but there may be better suggestions out there?
>
> Any thoughts?
>
>
>
>
> Read this topic online here:
>
> http://forums.matronics.com/viewtopic.php?p=445500#445500
>
>
>
>
>
>
>
>
>
>
|