You say you set the controller to 4800 for cruise. Is that in manual mode? The
factory setting is 5100 I think, which is the minimum cruise RPM recommended.
I think you might want to refer to the airmaster manual.
Kevin
> On Oct 11, 2015, at 10:46 PM, Roland <schmidtroland@web.de> wrote:
>
>
> Hi,
>
> I've set the Airmaster Controller for a cruise of 4800 RPM. That works good at
low altitudes.
>
> However, when I go up high (highest was FL 180 by now), I have to reduce
> throttle
in cruise to not over rev the engine (at least to stay below MCP of 5500
RPM).
>
> I read about some US-Europa-owners also flying high frequently.
>
> Is there any course pitch stop-setting to recommend for high altitudes (any
> rule
of thump maybe)?
>
> I think, that the Warp Drive blades are not first choice for high altitude but
that's another story.
>
> Thanks
> Roland
> PH-ZTI
> XS TG 914
>
>
>
>
> Read this topic online here:
>
> http://forums.matronics.com/viewtopic.php?p=447837#447837
>
>
>
>
>
>
>
>
>
>
|