Just to be certain, i only want to do this once!!!!
Did you translate the angle from the drawings on Mod 76.
Dave
Sent from my iPhone
> On 25 Nov 2015, at 09:28, roddyeuropa@aol.com wrote:
>
> I did this mod a couple of years back and used the original CS10 torque tu
be, and had the europa supplied lugs welded on by a local specialist aircraf
t welder. I preferred to keep the original control system as much the same a
s possible. Getting the lugs welded on was not the hardest part - its a lot o
f work to get the torque tube out, and also very fiddly to connect the new s
ervo rod - there is just so little room to work.
> In answer to your question "I just want to confirm that the Alt. Hold horn
is exactly the same orientation as the Stabilator port horn" I'm pretty sur
e that the horn is not the same orientation, but the drawings in mod 76 show
the correct position. The position is vital - I made a jig to hold it in pl
ace so there was no question of the welder putting it in the wrong place. So
good luck!
> Roddy Kesterton
> G-IKRK
>
>
>
> -----Original Message-----
> From: david park <dpark748@icloud.com>
> To: europa-list <europa-list@matronics.com>
> Sent: Tue, 24 Nov 2015 23:16
> Subject: Re: Europa-List: Re: Altitude Hold kit. Trio.
>
>
> Europa supply a kit to modify the CS10 by welding the two horns onto the C
S10 to take the pushrod from the servo.
> Dave
>
> Sent from my iPhone
>
>
> > On 24 Nov 2015, at 22:12, graeme bird <graeme@gdbmk.co.uk> wrote:
> >
> >
> > Have you replaced cs10 then ? How easy was it?
> > It sounds like you are adding horns to the existing.
> >
> > --------
> > Graeme Bird
> > G-UMPY
> > Mono Classic/XS FFW 912S/Woodcomp 3000/3W
> > Newby: 200 hours 4 years on the Mono
> > g@gdbmk.co.uk
> >
> >
> >
> >
> > Read this topic online here:
> >
> > http://forums.matronics.com/viewtopic.php?p=450192#450192
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
>
>
>
>
>
|