Hi Clive,
Hope this goes through, my posts have gone MIA before
Mod 15, the ''top hat'' lay up of 3 Bids over 3'' x 1/4'' blue foam, vertical
from
door sill to thigh support, centred over lift socket.
Mod 16, original block was a rectangular ''brick'', needs a V cutting out of
upper
and lower faces [ bear to do, get a new one from Europa].
Mod 17, without my notes can't be sure, might be the 5/8'' tubes [CS31] Reduxed
into the pedal pivot tubes ?
Mod 46 Pitch torque tube originally had the solid bearings [ as per aileron
control
system] replaced with a spherical [ self aligning] bearing and beefier cap.
All these were very early on.
Tip, when you submit the paperwork to LaaLaaLand, list EVERY MOD, and mark as
N/A
as [ for instance] a Trigear application will be returned if the mono wheel
block, Mod 16 hasn't been done..... DOH !
Cheers,
Nev
-----Original Message-----
From: clivesutton <clive.maf@googlemail.com>
Sent: Sat, 11 Mar 2017 19:55
Subject: Europa-List: MOD sheets?
Hi, on the final inspection prep run now and checking off each required MOD with
the LAA list against what's on the a/c.
But can't find anything on the EC or Europa websites for the following MOD's -
Does anyone have/can send me, copies please?
MOD 15 - FWD Lift Pin Fuselage Strengthening
MOD 16 - Shock Absorber Block Shape
MOD 17 - Rudder Pedal guides
MOD46 - Pitch Torque Tube End Cap
clive.maf@googlemail.com
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=467178#467178
|