Ok thanks...so from the pic in the manual we are talking level suspended
---From the hinge underside uppermost....right?
Will
On Mar 12, 2017 09:26, "Bob Harrison" <ptag.dev@talktalk.net> wrote:
> William. If you were to compare the volume /weight removed between =C2
=BC=9D
> hole to a =C2=BD=9D hole the difference would be huge. So small bi
ts but often is
> the order of the plan. Then you have to fill the holes with some foam and
> glass it over and repaint . Quite a lot of patience needed to complete i
t !
>
> Regards
>
> Bob Harrison G-PTAG
>
>
> *From:* owner-europa-list-server@matronics.com [mailto:owner-europa-list-
> server@matronics.com] *On Behalf Of *William Daniell
> *Sent:* 12 March 2017 12:49
> *To:* europa-list@matronics.com
> *Subject:* RE: Europa-List: Aileron balancing
>
>
> Yes i have
>
> Will
>
>
> On Mar 12, 2017 04:02, "Bob Harrison" <ptag.dev@tiscali.co.uk> wrote:
>
> Hi! William .
>
> Have you painted them yet ?
>
> Regards
>
> Bob H G-PTAG
>
>
> *From:* owner-europa-list-server@matronics.com [mailto:owner-europa-list-
> server@matronics.com] *On Behalf Of *William Daniell
> *Sent:* 12 March 2017 01:39
> *To:* europa-list@matronics.com
> *Subject:* Europa-List: Aileron balancing
>
>
> Dear all
>
>
> I drilled a 1/4 hole in each aileron weight with very little effect. The
> hinges are free amd i dont think im doing anything wrong.
>
>
> Is this normal? What next? 1/2" hole?
>
>
> Help please.
>
>
> Will
>
> No virus found in this message.
> Checked by AVG - www.avg.com
> Version: 03/12/17
>
> No virus found in this message.
> Checked by AVG - www.avg.com
> Version: 03/12/17
>
|