Hi! William,
I haven=99t a manual handy but that sounds about right .
Regards
Bob H
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com] On Behalf Of William
Daniell
Sent: 12 March 2017 14:39
Subject: RE: Europa-List: Aileron balancing
Ok thanks...so from the pic in the manual we are talking level suspended
---From the hinge underside uppermost....right?
Will
On Mar 12, 2017 09:26, "Bob Harrison" <ptag.dev@talktalk.net> wrote:
William. If you were to compare the volume /weight removed between
=C2=BC=9D hole to a =C2=BD=9D hole the difference would be
huge. So small bits but often is the order of the plan. Then you have to
fill the holes with some foam and glass it over and repaint . Quite a
lot of patience needed to complete it !
Regards
Bob Harrison G-PTAG
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com] On Behalf Of William
Daniell
Sent: 12 March 2017 12:49
Subject: RE: Europa-List: Aileron balancing
Yes i have
Will
On Mar 12, 2017 04:02, "Bob Harrison" <ptag.dev@tiscali.co.uk> wrote:
Hi! William .
Have you painted them yet ?
Regards
Bob H G-PTAG
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com] On Behalf Of William
Daniell
Sent: 12 March 2017 01:39
Subject: Europa-List: Aileron balancing
Dear all
I drilled a 1/4 hole in each aileron weight with very little effect.
The hinges are free amd i dont think im doing anything wrong.
Is this normal? What next? 1/2" hole?
Help please.
Will
No virus found in this message.
Checked by AVG - www.avg.com
Version: 03/12/17
No virus found in this message.
Checked by AVG - www.avg.com
Version: 03/12/17
No virus found in this message.
Checked by AVG - www.avg.com <http://www.avg.com/email-signature>
03/12/17
|