Hi everyone,
Im wondering if anyone else has encountered this problem with the trim damper
assembly
as I have.
>From Page 19-2 - Figure 2, the TS04A bolt is placed through the support bracket
- however, when I installed the Nyloc Nut M10 and putting in safety (only by
about 1 thread). The spring is fully compressed and causes binding with
operating
the electric trim.
I can't see an easy way out of this and I have been thinking of removing the
spring
and cutting one or two spirals of the spring.
Can anyone kindly offer some wisdom on this?
Many thanks
Tony
--------
Tony Vaccarella
Mascot NSW 2020
Sydney Australia
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=510382#510382
|