Not had a problem.
Whenever Ive come across something thats doesnt seem to work I always go back to
the manual to check I have the right items and assembled them correctly.
For example the thickness washer placed under the head of a bolt instead of the
nut meant the shoulder of the bolt did not go all the way through a control rod
end resulting in too much play in the control. Corrected and all works fine.
Alan
Sent from my iPhone
> On 11 Mar 2023, at 11:04, tonyvaccarella <tony@weimagine.com.au> wrote:
>
>
> Hi everyone,
>
> Im wondering if anyone else has encountered this problem with the trim damper
assembly as I have.
>
>> From Page 19-2 - Figure 2, the TS04A bolt is placed through the support
>> bracket
- however, when I installed the Nyloc Nut M10 and putting in safety (only
by about 1 thread). The spring is fully compressed and causes binding with
operating
the electric trim.
>
> I can't see an easy way out of this and I have been thinking of removing the
spring and cutting one or two spirals of the spring.
>
> Can anyone kindly offer some wisdom on this?
>
> Many thanks
> Tony
>
> --------
> Tony Vaccarella
> Mascot NSW 2020
> Sydney Australia
>
>
>
>
> Read this topic online here:
>
> http://forums.matronics.com/viewtopic.php?p=510382#510382
>
>
>
>
>
>
>
>
>
|