Hello all, in the absence of the factory for parts, a kit that has been waiting
to be finished for a few decades and now is in progress again, the stabilator
axis has been found to have one end about 8mm higher than the other.
If the plastic bush needs replacing after the removal, can anyone help with
material
spec and dimensions to make up a new one?
Also, the modification to strengthen the counterweight installation was deemed
necessary due to a bent arm, I gather.
Has it been considered if cushioning of the mass before end of travel could
achieve
what the beefing up of the arm sought to do?
Best regards,
Alex Kaarsberg, kit 529
|