Hi Brian-
Thanks, yes that would be very much appreciated!!
Alex Kaarsberg
> On 13 Nov 2024, at 23:14, Al <barp99@gmail.com> wrote:
>
>
> Alex,
>
> My bushes are yet to be fitted, so could measure them up for you if needed,
> I'm
away from it for a couple of weeks but after that will have access.
>
> Brian Phillips
>
> Aus.
>
>> On 14/11/2024 9:25 am, Alex Kaarsberg wrote:
>>
>> Hello all, in the absence of the factory for parts, a kit that has been
>> waiting
to be finished for a few decades and now is in progress again, the stabilator
axis has been found to have one end about 8mm higher than the other.
>> If the plastic bush needs replacing after the removal, can anyone help with
material spec and dimensions to make up a new one?
>>
>> Also, the modification to strengthen the counterweight installation was
>> deemed
necessary due to a bent arm, I gather.
>> Has it been considered if cushioning of the mass before end of travel could
achieve what the beefing up of the arm sought to do?
>>
>> Best regards,
>> Alex Kaarsberg, kit 529
>>
>>
>>
>
>
>
|