Forward facing portion? What might that be...the
flanges all run parallel to the water line
Paul Boulet A212--- Fred Fillinger
<fillinger@ameritech.net> wrote:
> "Tony S. Krzyzewski" wrote:
>
> > You'll need to trim the edges to get a tidy join
> when the two parts
> > overlap. Believe me, a 1" overlapped joint glued
> with Redux is going to
> > be so strong you'll never have to worry about it.
> Keeping the joint to
> > the required size is also going to save you the
> weight of the extra edge
> > plus the weight of the Redux.
> > ....
>
> Not to mention that Redux is hideously expensive if
> you run out!
>
> I would add that you should leave some extra flange
> on the
> forward-facing, vertical portion back near the fin.
> If you can't pull
> the top back quite far enough, you'll need it. Just
> in case, of
> course; all Europa parts are a perfect fit, right?
> :-)
>
> Regards,
> Fred F., A063
>
> The Europa List is supported by Aviators Network UK
> - info@avnet.co.uk
|