hey, only one kit before me :-)
> How can I tell if the epoxy Ive used yesterday (and the days before)
> are O.K. ???
A first (but only very basic) check....
Did you keep samples of each mix? If not then I would recommend it in the
future. Do you have some scraps out of mixing pots if you don't have the
sample?
First, cut the surface with a craft knife. It should have left a clean scrape
with no ridging. If there is ridging then the epoxy mix was badly out.
Second, cut a thin section out of the sample and submit it to the German snap
test. Simply apply force until it snaps. It should break with a clean
sounding snap, anything else is a reject.
Other than that, I suspect you may need some more expert advice - see your
technical counsellor or inspector.
Tony #272
---------------------------------------------------
Tony Krzyzewski tonyk@kaon.co.nz
Managing Director Ph 64 9 358 9124
Kaon Technologies Fx 64 9 358 9127
Auckland
New Zealand
Networkers visit www.kaon.co.nz
Aviators visit www.kaon.co.nz/europa/272index.html
----------------------------------------------------
|