Sounds like you got off OK.
I check my calibration at the start of each major section - around 3-4 weeks
apart. So far it has been spot on every time but it is a matter of pure faith
that it doesn't drift between checks.
I am doing my second wing layup tomorrow. Fingers crossed it will go as
smoothly as the first.
Have a good weekend
Tony
------------------------
From: "Norbert P. Hoffmann" <nphffmn@ibm.net>
Subject: Re: --- PANIC ---
Date: Thu, 15 May 1997 13:05:47 +1200
> Tony, I may be one kit before you, but judging from your excellent
> Builders Log, Im way behind you in building the Europa.
>
> I repaired my epoxy pump today - a real mess! One of the valves got
> stuck. The pump seems to work all right again. For the time being Im
> checking it each time by weighing the hardener and the resin, than
> mixing it together. A bit paranoid ...
>
> Yes, I kept samples of each mix, actually I kept them in two forms: the
> remainder in the cup and samples on a piece of paper. All of the samples
> passed the tests you suggested. I might have recognized the problem at
> the instance it was happening. It seems that I was lucky. Nevertheless I
> will see my inspector to discuss this with him.
>
>
> Norbert
> #271
>
---------------End of Original Message-----------------
---------------------------------------------------
Tony Krzyzewski tonyk@kaon.co.nz
Managing Director Ph 64 9 358 9124
Kaon Technologies Fx 64 9 358 9127
Auckland
New Zealand
Networkers visit www.kaon.co.nz
Aviators visit www.kaon.co.nz/europa/272index.html
----------------------------------------------------
|