22>
<2OtB3GARlZz0EwHQ@globalvt.demon.co.uk>
Caution about rushing in to cut holes in your seat back. This is a load
carrying member and, on Grahams request, are carrying out stress analysis.
I may be recommended not to do it.
regards Andy
>Rolph,
>This is just a tip Neville gave me. The bolts are such a precise fit in
>the push rod bearings that on re-assembly through such a small hole
>you have difficulty in re- inserting the bolt. By pre inserting a
>centralising tool (merely a bolt of the same size with a filed or
>ground conical end to the thread) you can re-insert the bolt easily,
>pushing out the centralising tool in the process.
>On the other hand, Graham's idea of cutting the hole in the seat
>back would make this task much easier!
>Roger
>
>
|