I found the same problem when positioning the slot. If I put it where the
book said it would be too far to the left. Moving it to the right would
make the lever interfere with the instrument module. After carefully
positioning everything (the instrument module is as far to the right side
as it woud go) i ended up with a slot that required the aluminum plate to
overhang the side of the tunnel about 3/8 inch. This overhang was filled
in later with flox.
Bill Stewart, A098
----------
> From: Terry Seaver <terrys@cisco.com>
> Subject: XS retraction lever slot
> Date: Monday, November 01, 1999 3:48 PM
>
> My XS manual says I should cut a 10mm wide
> slot in the top of the tunnel for the retraction lever,
> 75/85mm from the center line. When I mark the
> proposed slot in pen it goes off the left side of the
> top of the tunnel at the rear part of the slot.
> Trimming the aluminum cover plate to the tunnel
> side would leave no material on the left side
> of the slot in the plate.
>
> It seems the slot needs to be at least 10mm
> further to the right, but I wonder about
> possible interference in the wheel well
> with other components.
>
> Has anyone else noticed this ?
>
> Terry Seaver
> A135
>
>
|