Terry,
I had the same problem. My solution was to build up the tunnel with
foam and 2 layers of bid just under the cover plate. The result looked much
better than I thought it would.
regards,
Mike Parkin, No312
-----Original Message-----
From: Terry Seaver <terrys@cisco.com>
Date: 01 November 1999 20:50
Subject: XS retraction lever slot
>My XS manual says I should cut a 10mm wide
>slot in the top of the tunnel for the retraction lever,
>75/85mm from the center line. When I mark the
>proposed slot in pen it goes off the left side of the
>top of the tunnel at the rear part of the slot.
>Trimming the aluminum cover plate to the tunnel
>side would leave no material on the left side
>of the slot in the plate.
>
>It seems the slot needs to be at least 10mm
>further to the right, but I wonder about
>possible interference in the wheel well
>with other components.
>
>Has anyone else noticed this ?
>
>Terry Seaver
>A135
>
>
|