RE: Front Bearing setup

Subject:	RE: Front Bearing setup
From:	Roger Sheridan <rogersheridan@btinternet.com>
Date:	Thu, 16 Nov 2000 10:02:20

FWIW I am not putting grease on anything till the plane is finished as it
has a great affinity for glass dust, and have used graphite powder where
lubrication is essential.
To avoid misaligning the tufnol bearings I did not drill or bolt them until
after the flox had set.

Rog Sheridan.

<Prev in Thread]	Current Thread	[Next in Thread>
RE: Front Bearing setup, (continued) RE: Front Bearing setup, Tony Krzyzewski Re: Front Bearing setup, Tony Renshaw Re: Front Bearing setup, Brian Rauchfuss - PCD Re: Front Bearing setup, J van Heeswijk Re: Front Bearing setup, Tom & Cathy Friedland Re: Front Bearing setup, ami mcfadyean Re: Front Bearing setup, Carl Pattinson Re: Front Bearing setup, Carl Pattinson Re: Front Bearing setup, Graham Singleton Re: Front Bearing setup, Miles McCallum RE: Front Bearing setup, Roger Sheridan <= RE: Front Bearing setup, Robert Berube Re: Front Bearing setup, Fred Fillinger Re: Front Bearing setup, Grahamclk RE: Front Bearing setup, Robert Berube Re: Front Bearing setup, Fred Fillinger

Previous by Date:	Bob Archer Antenna, Barrington Tennant
Next by Date:	RE: Things that go bump in the flight/Carb ice?, Roger Sheridan
Previous by Thread:	Re: Front Bearing setup, Miles McCallum
Next by Thread:	RE: Front Bearing setup, Robert Berube
Indexes:	[Date] [Thread] [Top] [All Lists]