Re: Front Bearing setup

Subject:	Re: Front Bearing setup
From:	Grahamclk@aol.com
Date:	Fri, 17 Nov 2000 06:41:42

In a message dated 15/11/2000 14:49:10 GMT Standard Time, 
jac.vanheeswijk@hetnet.nl writes:

<< "If more than 4lbs (17N) of force is used to control the aircraft at the 
servo attachment point, then do not use."   >>

Wow, that translates to 8 oz. at the hand !  The aerodynamic loads alone must 
be near to this !   

Graham G-EMIN

<Prev in Thread]	Current Thread	[Next in Thread>
Re: Front Bearing setup, (continued) Re: Front Bearing setup, J van Heeswijk Re: Front Bearing setup, Tom & Cathy Friedland Re: Front Bearing setup, ami mcfadyean Re: Front Bearing setup, Carl Pattinson Re: Front Bearing setup, Carl Pattinson Re: Front Bearing setup, Graham Singleton Re: Front Bearing setup, Miles McCallum RE: Front Bearing setup, Roger Sheridan RE: Front Bearing setup, Robert Berube Re: Front Bearing setup, Fred Fillinger Re: Front Bearing setup, Grahamclk <= RE: Front Bearing setup, Robert Berube Re: Front Bearing setup, Fred Fillinger

Previous by Date:	Re: Front Bearing setup, Fred Fillinger
Next by Date:	Re: Fuel head sensing, Grahamclk
Previous by Thread:	Re: Front Bearing setup, Fred Fillinger
Next by Thread:	RE: Front Bearing setup, Robert Berube
Indexes:	[Date] [Thread] [Top] [All Lists]