David Joyce has reminded me that for many people the small holes are
as hard to get right as the big ones ...
>----- Original Message -----
From: Rowland & Wilma Carson <rowil@clara.net>
>Subject: instrument sub-panel
> > I didn't bother to include the mounting
> > holes for instruments or for the panel itself, as they can easily be
> > drilled in the home workshop.
>
From: "david joyce" <davidjoyce@beeb.net>
>Subject: Re: instrument sub-panel
>Date: Sat, 26 Jan 2002 17:37:29 -0000
>
>Rowland, I would say that cutting the screw holes is the most difficult part
>of the panel, and very easy to make a mess of
>I used the original panel material (Fibreglas
>covered plywood) and found positioning the instrument holes and cutting them
>was easy, but not so the screw holes
So if you can get accurate measurements of where all those wee holes
have to be, you might as well get them done by water-jet at the same
time.
regards
Rowland
| Wilma & Rowland Carson <rowil@clara.net> <http://home.clara.net/rowil/>
| ... that's Rowland with a 'w' ...
|