| Subject: | Re: Bending hinge pins |
|---|---|
| From: | Brian Rauchfuss - PCD <brauchfu@pcocd2.intel.com> |
| Date: | Mon, 6 May 2002 11:04:06 |
To bend hinge pins I use my vise. Put a little less than 1/4" in the vise and apply pressure. The bend will occur right after the point that is in the vise. This has worked well for me. Brian Rauchfuss A72 |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: Test...test.....Is this on....?, Richard Holder |
|---|---|
| Next by Date: | Re: Bending hinge pins, Terry Seaver |
| Previous by Thread: | Re: Flying: Fuel drawback entitlement : UK to, Richard Holder |
| Next by Thread: | Re: Bending hinge pins, Terry Seaver |
| Indexes: | [Date] [Thread] [Top] [All Lists] |