Both!
Good idea. But let us all know what you find that is able to make the hole.
Duncan McFadyean
On Monday, May 06, 2002 8:05 PM, Shaun Simpkins [SMTP:shauns@hevanet.com] wrote:
> After an epoxying incident which required me to disassemble the
> hinges ( to clean them ), I found that it's dang difficult to get the
> pins out without cutting a large clearance in the fiberglass flanges. Putting
it back
> in without easing the end of the pin will score the inside of the hinge
> holes as the pin has to be bent at a slight angle to clear the flange.
>
> Since one has to cut off the bent part to pull the pin, it got me thinking
> that maybe a better way would be to run some 0.032 stainless safety wire
> through a hole drilled in the pin, and leave it straight. One still has to
> relieve the fiberglass...
>
> Smart? Stupid?
>
> Shaun
> A207
|