Ralph.
All the fittings I purchased are 37 degrees. I think it is mostly
automotive stuff I've seen that is 45 degrees. I could be wrong about that
part.
Jeff
"R.K. Hallett III" wrote:
> All,
> I've been making up some fuel lines from AL and using AN fittings. The
> question is about the flaring tool. The die block states that it is a
> 37 deg flare where as the cone has 45 deg etched on the cone side.
> Shouldn't the cone be 37 deg as well? I called Spruce and now everyone
> is confused. Your thoughts please.
>
> Ralph
> Motorglider(parts)
> Reno,NV
|