Hi All,
If you take a look at http://europa363.versadev.com/nov-01.html you will
see how I made up flat plates to go on the side of the push rods. I did
this before that factory issued any mods, so I don't know if its the same.
The usual caveat applies.... when in doubt the factory is right and I am
wrong.
Cheers, Paul
http://europa363.versadev.com
----- Original Message -----
From: "Richard" <riddon@btinternet.com>
Subject: Re: Door latch push rods
> PAUL,
>
> I don't know if you have got the latest idea from the factory ref. the
push
> rods which amends the idea of creating the slots by filing the rod, to
> riveting on some pieces on the side instead. If not, I would contact the
> factory for details and this may well give you some spare length of rod to
> play with. The finished job is better also.
>
> Richard Iddon. G-RIXS
>
> -----Original Message-----
> From: forum-owner@europaclub.org.uk
> Subject: Re: Door latch push rods
>
>
> Have just spent hours cutting filing and drilling the door latch push
rods,
> according to the instructions in my build manual. Now discover there are
> amended dimensions, and my push rods are 4mm too short. Before either
> fitting them or throwing them away to start again, any one done the same
and
> what were the consequenses if any.
>
> Regards
>
> Paul Stewart #432
>
>
|