As I' ve just gone about setting the tailplane pitch to factory spec's of +12
Deg Up and -4 Deg down, I've got a little problem. I can get plenty of pitch
down
but have cut the opening ( for the trim tab rod) all the way up to the "joggle"
where the top and bottom mate and am reluntant to go any further until I
check an see if this is normal. I would have to cut approximately another 1/2"
up into the Joggle to achieve 12 deg up. I' ve got approx 11 deg up to the
botton
of the joggle. What has been the experience of some of you that have been
there before me.
Al Stills
A095
|