To all who answered.a hearty thanks. I guess Tony and I are not the only ones
with
this problem and quite a few had to cut up into the joggle a little bit. I've
been advised not to finish up right now but wait until the top is on to finish
the cut which I think will go approx: 1/2" into the joint of the top and
bottom for the 12 deg. I'm approx 11.25 now just below the joggle. Tony, you and
I are about the same. I'm building a tri-gear so think the factory specs of
+12 -4 will do, although I have about -8 on the bottom side.Sorry for so late
a post in answering as have been off the network for 2 days..thanks again. BTW
if a little appreshensive about the strength of the joint, after joining
togeather
I can always lay up a couple of pieces of bid across the area. (suggestion
by Steve Hager who had to do the same). I guess not all "Kits" are identical.
Al Stills
A095
|