Gidday,
Is there an easy way to place the 6 mm roll pin into the 4.8 mm holes in
the LG 08s ??? Looks fairly impossible to me without opening up a tapered
guide hole in the LG 08, but I don't want to do that without first asking
around.
Reg
Tony Renshaw
Sydney Australia
Classic 236 B.B. Taildragger
Tail, Wings, Ailerons, Flaps Complete and Connected
Lower Fuse in Jig, and module most recently installed.
Tail Torque Tube installed.
Mass Balance assembly installed and deflections sorted
Roof Panel between doors completed.
Photos at:
http://forum.okhuijsen.org/TonyR
Intended Engine: 912S CS prop (model undecided)
Instrumentation: Garmin 296 Colour GPS beneath an electronic Artificial
Horizon, one that I can trust for short periods IMC, to get out of a sticky
situation
|