Thanks Stephan,
I need to read the manual properly. Haven't opened the 4.8 holes out yet to
6 mm. Der!!!!
Reg
Tony Renshaw
At 10:14 PM 9/3/2004, you wrote:
>
>Hi Tony,
>
>I thought so too but it went in without any problem. Knock Knock with
>a hamer
>
>Reg
>Stephan
>
>
> > <tonyrenshaw@optusnet.com.au>
> >
> > Gidday,
> > Is there an easy way to place the 6 mm roll pin into the 4.8 mm holes
> > in the LG 08s ??? Looks fairly impossible to me without opening up a
> > tapered guide hole in the LG 08, but I don't want to do that without
> > first asking around.
> >
> > Reg
> > Tony Renshaw
> > Sydney Australia
> >
> > Classic 236 B.B. Taildragger
> > Tail, Wings, Ailerons, Flaps Complete and Connected
> > Lower Fuse in Jig, and module most recently installed.
> > Tail Torque Tube installed.
> > Mass Balance assembly installed and deflections sorted
> > Roof Panel between doors completed.
> > Photos at:
> > http://forum.okhuijsen.org/TonyR
> > Intended Engine: 912S CS prop (model undecided)
> > Instrumentation: Garmin 296 Colour GPS beneath an electronic Artificial
> > Horizon, one that I can trust for short periods IMC, to get out of a
> > sticky situation
> >
> >
> > _-
>========================================================================
> > _-
>========================================================================
> > _-
>========================================================================
> > _-
>========================================================================
>
>
|