Hi Tony,
I thought so too but it went in without any problem. Knock Knock with
a hamer
Reg
Stephan
> <tonyrenshaw@optusnet.com.au>
>
> Gidday,
> Is there an easy way to place the 6 mm roll pin into the 4.8 mm holes
> in the LG 08s ??? Looks fairly impossible to me without opening up a
> tapered guide hole in the LG 08, but I don't want to do that without
> first asking around.
>
> Reg
> Tony Renshaw
> Sydney Australia
>
> Classic 236 B.B. Taildragger
> Tail, Wings, Ailerons, Flaps Complete and Connected
> Lower Fuse in Jig, and module most recently installed.
> Tail Torque Tube installed.
> Mass Balance assembly installed and deflections sorted
> Roof Panel between doors completed.
> Photos at:
> http://forum.okhuijsen.org/TonyR
> Intended Engine: 912S CS prop (model undecided)
> Instrumentation: Garmin 296 Colour GPS beneath an electronic Artificial
> Horizon, one that I can trust for short periods IMC, to get out of a
> sticky situation
>
>
> _-
========================================================================
> _-
========================================================================
> _-
========================================================================
> _-
========================================================================
|