Fred,
WRT:
> To sum up, looking at McMaster-Carr catalogue pg. 3088, you find a
picture
> of the aluminum "T" handle type "G" quick release pin; this APPEARS
to be
> EXACTLY like that supplied w/ kit. Going to pg. 3089, you find part
> #90293A415 which is a "T" handle pip pin w/ 2 balls of 1/2" Dia. w/ 3
1/2"
> grip range at $29.30 ea.
>
> Also, because of the postings telling of the use of hammers to remove
and
> insert pins, one may be interested in a heavy duty 2 ball quick
release pin,
> part #90980A555 which has a welded steel "T" handle at $57.08 each, a
1/2"
> pin which has a 3 1/2" usable length.
I agree completely. Either of those is what we want.
Good building & great flying.
Bob Borger
Europa Kit #A221 N914XL, XS Mono, 914, Airmaster C/S
http://forum.okhuijsen.org/N914XL
(75%) tail kit done, wings closed, cockpit module installed, pitch
system in, landing gear frame in, rudder system in, outrigger mod in,
Fuselage Top on, lift/drag/flap pins in, wing incidence set, tie bar
in, flap drive in. Working in - 24 Instrument Panel, 25 Electrical, 27
Setting Wings, 28 Flaps, 29 Main Gear, 30 Fuel System, 32 Tail, 34 Door
Latches & 35 Doors, 37 Finishing.
3705 Lynchburg Dr.
Corinth, TX 76208
Home: 940-497-2123
Cel: 817-992-1117
|