2.60 REPLY_TO_EMPTY Reply-To: is empty
Brian,
TP12s could have been drilled into the torque tube in the wrong spot. I'm in the
hanger now so I can't pop out and get the measurements. If they're not posted
I'll get them for you tomorrow.
Put everything together, torque tube, TP-11, TP-12 and pin. Then measure TP-11s
---From center to center. We can only hope it's 255 mm.
I'm not sure what the calcs where for TP-11 and keeping it in place, maybe 1/8
is ok, but is sounds light.
Chat Later,
Steved
----------------
Visit EuropaOwnersForum http://www.europaowners.org/
|