2.60 REPLY_TO_EMPTY Reply-To: is empty
I got to the hanger, it's hard to measure the torque tube stuff when its
installed.
I measured the inside to inside edge of TP12. Got 141 mm. I lucked out and
my bushings centered.
I got a tip for installing TP10 plastic tube. I found that I pushed on them
while
trying to drill the hole. This made them bind on TP11 bushings. What I did
was put TP10 edge down on two layers of thin duct tape. Then I cut around the
outside then the inside. So I had a duct tape O on the end of the tube. Then you
can put TP10 up tight against TP11. Drill the hole for the pin. Remove the
tape and the gap is perfect.
Chat Later,
Steved.
----------------
Visit EuropaOwnersForum http://www.europaowners.org/
|