Brian,
Never mind the radius, just enlarge it a little ON THE SIDES, NOT REDUCING
THE DISTANCE TO THE 0.25" HOLE ON TOP!!. The template shall rest on the
torque tube, see fig. 5 in the manual. The essential dimension is the
distance from the surface of the torque tube to the underside of the
bellcrank bolt:
109.2-19-6.4/2=87.0 mm - see the template drawing in fig. 3 in Annex A.
Good luck!
Regards,
Svein
A225 - XS Trigear - now in Norway
----- Original Message -----
From: <EuropaXSA276@aol.com>
Subject: Europa-List: TST template and Trim Bellcrank.
>
> I'm trying to install the critical distance of the trim bellcrank with the
> TST template. < Page 19-4>
> The dimension given for the radius appear to be smaller that the TP4 tube
> dimension.
> That aside, I need to know if this template should be resting on the TP4
> tube
> or the TP9 drive horn. This would certainly make as difference in the
> height
> of the trim bellcrank assembly thus throwing off the gearing of the tab to
> tail plane ratio.
>
> Thanks in advance!
> Brian Skelly
> Texas
> Europa # A276 TriGear
> See My build photos at:
> http://www.europaowners.org/BrianS
>
>
>
|