In a message dated 1/26/2005 3:26:20 PM Central Standard Time,
eckel1@comcast.net writes:
My torque tube measures 1.5 inches in Dia, the same as the template.
The template rests directly on the torque tube, see Fig. 5.
Suggestion--when mounting the TS01 and TS02 brackets use anchor nuts.
The same for the MAC trim servo. It will make removal and installation
of these parts so much easier if the need arises. (Ron Parigoris idea)
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
Good idea on those nutz John. As much as I do not what to think about it...
That servo will have to be replaced at some point. What kind of anchor nuts
did you use?
Back on this template. Did you use the template with the TP9 installed on
the tube?
The bolt will just barley touch with the trim assembly on center line and the
template on the tube and edge on the TP9. I can lean the template over for
good contact but that lowers the bracket!
Having one of those days....
Brian Skelly
Texas
Europa # A276 TriGear
See My build photos at:
http://www.europaowners.org/BrianS
|