Brian,
I used MS21047-3 anchor nuts to hold theTS01 and 02 brackets in place.
The trim servo is held in place with Tee nuts that can be bought in any
hardware store. I used Tee nuts instead of MS anchor nuts because I didn't
have
the right size in stock. I will send you a picture on my nuts...the ones on
the plane.
John
----- Original Message -----
From: <EuropaXSA276@aol.com>
Subject: Re: Europa-List: TST template and Trim Bellcrank.
>
> In a message dated 1/26/2005 3:26:20 PM Central Standard Time,
> eckel1@comcast.net writes:
> My torque tube measures 1.5 inches in Dia, the same as the template.
> The template rests directly on the torque tube, see Fig. 5.
>
> Suggestion--when mounting the TS01 and TS02 brackets use anchor nuts.
> The same for the MAC trim servo. It will make removal and installation
> of these parts so much easier if the need arises. (Ron Parigoris idea)
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
> Good idea on those nutz John. As much as I do not what to think about
> it...
> That servo will have to be replaced at some point. What kind of anchor
> nuts
> did you use?
>
> Back on this template. Did you use the template with the TP9 installed on
> the tube?
> The bolt will just barley touch with the trim assembly on center line and
> the
> template on the tube and edge on the TP9. I can lean the template over for
> good contact but that lowers the bracket!
>
> Having one of those days....
>
> Brian Skelly
> Texas
> Europa # A276 TriGear
> See My build photos at:
> http://www.europaowners.org/BrianS
>
>
>
|