Hi Mike,
Yes, I think all have to bend/cut in order to get free movement.
Regards,
Stephan
#556
-----Original Message-----
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com] On Behalf Of Mike Gamble
Subject: Europa-List: rudder pedal movement
<mp.gamble@tiscali.co.uk>
With the rudder pedals lined up in the neutral position I see that the
CS21 arms are about vertical.
The stb arm can move aft a little way before striking the side piece of
the stainless steel firewall but the port arm will very soon contact the
upper s/steel panel. Do people find that there is sufficient movement
availabe here as right rudder is applied or is bending/cutting of the
s/steel panel required?
Thanks
Mike Gamble
XS 440 mono
|