Hi Andrew
"I am not sure what the PVA release agent looks like. My cockpit module
> has very thick glossy stuff all over the the underside. It looks more
> like excessive epoxy. But I am concerned if this might be the PVA
> release agent. If so, it's not going to come off with any amount of
> washing in soap and water. Some heavy duty sanding would be in order.
> Does anyone have some advice on this?"
Use the hottest water you can tolerate, we used just plain green Palmolive
dish washing soap (great hand cleaner)and scotchbright pad. Once water
sheets rather than beads up you can switch to plain water and
scotchbright. You need to rinse off all the soap which is no trivial job.
Just keep rinsing, you could use green scouring pads (for sinks) as well.
When you think you got it all off, use some hot water "when" you see
bubbles forming, keep at it.
Ron Parigoris
|