Guys...
I have carelessly allowed the barb on the pitot tube connector used at
the wing root to be snapped off...these are those cute little white
nylon male/female connectors. I need a replacement. I note in the
Acft. Spruce catalog an item which APPEARS to be the right part; a P/
N 05-01036 which is listed as a fuel line connector for 1/4" tubing.
Inasmuch as the actual hole in the barb and tubing supplied w/ the kit
is only about 1/16" diameter, I question whether this size would be
appropriate for use as part of a fuel system.
Before I order the replacement part, is there anyone who can verify
that the P/N above is the correct size for the pitot system?
Thankx,
Fred
A194
--
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.
|