Karl Heindl wrote:
>
>
> Graham,
>
> I fully understand, but one would check before installation that the
> tubes slide easily over the torque tube.
> I did have the swarf problem on one side early in the build because I
> did not use a brand new drill bit. It was quite a job to fix that with
> a special homemade abrasive tool.
> I think there must be a simple way for new builders to drill the pip
> pin holes BEFORE installing a single tube.
>
> Karl
>
Karl
if you have any good ideas I'm sure the factory would like to know, they
are working to smooth out the wrinkles in the old design. OTH maybe they
already have an idea about this, David?
Graham
|