Yup sure is
thanks
Will
On 19-Oct-10 20:56, Troy Maynor wrote:
> --> Europa-List message posted by: "Troy Maynor"<wingnut54@charter.net>
>
> Hi Bill,
> Perhaps these pix on the gallery link might help. I put sheet silicone, held
with little stainless strips, around the holes cut for the engine mount. This
provides a good seal around the tubes. There was a good deal of trimming with
a dremel to get a good fit. I was going to use fire caulk around the seams but
ended up putting insulation over the whole thing anyway so I ommited the
sealant.
Hope this helps.
> Troy Maynor
>
>
> http://www.europaowners.org/forums/gallery2.php?g2_itemId=44024
>
>
> Read this topic online here:
>
> http://forums.matronics.com/viewtopic.php?p=316406#316406
>
>
> .
>
|