Hi Bill,
Perhaps these pix on the gallery link might help. I put sheet silicone, held
with
little stainless strips, around the holes cut for the engine mount. This
provides
a good seal around the tubes. There was a good deal of trimming with a
dremel to get a good fit. I was going to use fire caulk around the seams but
ended
up putting insulation over the whole thing anyway so I ommited the sealant.
Hope this helps.
Troy Maynor
http://www.europaowners.org/forums/gallery2.php?g2_itemId=44024
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=316406#316406
|