[quote="Troy Maynor"]Hi Bill,
Perhaps these pix on the gallery link might help. I put sheet silicone, held
with
little stainless strips, around the holes cut for the engine mount. This
provides
a good seal around the tubes. There was a good deal of trimming with a
dremel to get a good fit. I was going to use fire caulk around the seams but
ended
up putting insulation over the whole thing anyway so I ommited the sealant.
Hope this helps.
Troy Maynor
Thanks Troy, That is very helpful and a good idea- the sheet silicone makes a
nice
neat job of it.
Regards
Bill
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=316556#316556
|